How to replace the display on an iPhone 15
The iPhone 15 display (OLED 6.1" with Dynamic Island across the entire range) requires attention to the top sensors and testing of the Dynamic Island. This guide covers the complete procedure. Average time: 25-35 minutes. Difficulty: medium.
Warnings Before You Start
- The entire iPhone 15 range has Dynamic Island: carefully transfer the top sensor module and test the Dynamic Island before closing the device.
- The Face ID flex must be transferred intact: if it breaks, Face ID is lost.
- Disconnect the battery before the display connectors. Do not exceed 80°C.
Required Parts
Recommended Tools
- Pentalobe P2 screwdriver
- Tri-wing Y000 screwdriver
- Phillips #00 screwdriver
- Suction cup with ring + spudgers
- Heating plate or hot air
- Anti-static tweezers
- iPhone 15 perimeter adhesive
Step-by-Step Procedure
- 1
Power off and remove the pentalobe screws
Fully power off the iPhone. Remove the 2 pentalobe P2 screws on the bottom edge.
- 2
Heat the perimeter and lift the display
Heat the edges to 70-80°C for 2-3 minutes. Apply the suction cup, create a gap with a spudger and slide it along the sides to cut the adhesive.
💡 Tip: Lift the display from the bottom, rotating it like the page of a book: the metal clips are on the top side. Never pull upward. - 3
Disconnect the battery, then the display connectors
Open to ~90°. Remove the tri-wing plate and FIRST disconnect the battery connector. Then remove the display connector cover (Phillips #00 screws) and disconnect the touch and display flex cables.
- 4
Transfer the reusable components to the new display
Carefully remove from the old display and transfer to the new one: earpiece speaker, top sensors, and the Face ID flex (NOT clonable, it must remain the phone's original). Follow the same assembly order.
💡 Tip: If you break the Face ID flex, Face ID will never work again on that phone. Handle it with extreme care. - 5
Connect and test the new display BEFORE closing
Connect only the display connectors (not the battery yet), power on temporarily and check: touch response across the entire surface, brightness, Dynamic Island, Face ID, earpiece audio. If everything is fine, disconnect again.
- 6
Clean and apply the new perimeter adhesive
Using 99% isopropyl alcohol, remove adhesive residue from the housing. Apply the new perimeter adhesive starting from one corner, pressing firmly along the entire edge.
- 7
Reassemble and test
Reconnect the display connectors, then the battery. Replace the cover and screws. Close the device, aligning the top clips and pressing along the perimeter for 1-2 minutes. Replace the pentalobe screws. Power on and run a complete test cycle.
Frequently Asked Questions
How much does an iPhone 15 B2B display cost?
On InParts: INCELL from about €95, with ZY frame from about €55, OLED soft from about €189. The choice depends on budget and required performance.
Does Dynamic Island work with a compatible display?
Yes, if the top sensor module (original to the phone) is correctly transferred to the new display. Dynamic Island is software + sensors, it doesn't depend on the panel type.
Does the iPhone 14 display work on the 15?
No: although both have Dynamic Island, connectors and calibration differ. You need the specific display for iPhone 15.
All Apple Spare Parts in Stock
20,000+ spare parts available, 24/48h shipping in Europe. Reserved B2B prices and no minimum order.